LCD for handset and 3D printing help needed

[Mychaela Falconia]

Hi Serg,

> So far so good. I think it fits well enough for prototyping purposes. I
> didn't need to do any major adjustments, just removed two extra pits and
> increased diameter of holes to 1.3 mm
>
> Here are some pictures https://photos.app.goo.gl/JnEG1PDttqF2g0uz2

Looks fine visually, though of course it is very difficult for me to
judge from the pictures alone, I really need to hold it in my hands -
and we are on opposite sides of the continent...

Also in the picture with the calipers, it is very difficult for me to
tell which dimension is being measured, and what is the reading.

The height increase provided by the spacer needs to be 1.5 mm - was
this specification met?

> With such small nozzle it takes about 10 minutes to make this part, I think
> it can go faster, but I used very safe settings, still have lots of room
> for improvement.
>
> I made two runs and results look repeatable.
>
> How many do you need for now?

If you could send me just one piece, it will greatly help me decide if
I can work with it for the handset design.  If I like the initial one
test piece, then another 5 pcs afterward should be enough.

TIA,
Mychaela