LCD for handset and 3D printing help needed

[Serg l]

The caliper on the picture is just a weight, so the LCD stays flat once
flat cable is folded :) On the other picture it is just a holder, no
readings :)

It is 1.5 mm thick, but I'd suggest 0.2 mm margin on to of the connector.
Maybe 0.8 mm would be better to start with?

I will make 10 over weekend and send them back around Monday.

On Fri, Jun 8, 2018 at 1:59 AM, Mychaela Falconia <
mychaela.falconia at gmail.com> wrote:

> Hi Serg,
>
> > So far so good. I think it fits well enough for prototyping purposes. I
> > didn't need to do any major adjustments, just removed two extra pits and
> > increased diameter of holes to 1.3 mm
> >
> > Here are some pictures https://photos.app.goo.gl/JnEG1PDttqF2g0uz2
>
> Looks fine visually, though of course it is very difficult for me to
> judge from the pictures alone, I really need to hold it in my hands -
> and we are on opposite sides of the continent...
>
> Also in the picture with the calipers, it is very difficult for me to
> tell which dimension is being measured, and what is the reading.
>
> The height increase provided by the spacer needs to be 1.5 mm - was
> this specification met?
>
> > With such small nozzle it takes about 10 minutes to make this part, I
> think
> > it can go faster, but I used very safe settings, still have lots of room
> > for improvement.
> >
> > I made two runs and results look repeatable.
> >
> > How many do you need for now?
>
> If you could send me just one piece, it will greatly help me decide if
> I can work with it for the handset design.  If I like the initial one
> test piece, then another 5 pcs afterward should be enough.
>
> TIA,
> Mychaela
> _______________________________________________
> Community mailing list
> Community at freecalypso.org
> https://www.freecalypso.org/mailman/listinfo/community
>