FCDEV3B bring-up status

[Serg l]

Another report. I flashed the image built by Mychaela, booted from it and
re-entered VCXO calibration values into FFS via tmsh.
The MS registered with the network in one shot without any problems.
I was able to make and receive calls and SMS. I concluded this test by a
shot of whiskey in order to celebrate this milestone of the project.

The next step would be to try Citrine with the same FFS content.

-Serg

On Tue, May 2, 2017 at 1:23 PM, Mychaela Falconia <
mychaela.falconia at gmail.com> wrote:

> Serg wrote:
>
> > Last night I have compiled in my VCXO calibration values into
> > citrine/L1/cust0/l1_rf12.h and used fcfam load agent to do x-ram boot.
>
> Please remember that neither Citrine's build system nor that of
> Magnetite tracks header file dependencies, so if you edit a header
> file (as opposed to a directly compiled C module file) and rerun make
> in an already-compiled tree, it may not pick up your change - you may
> need to do at least a partial make clean in the area of change.  In
> the case of your change in Citrine, did you do a make clean at least
> in L1/cust0?
>
> > Still no joy locking on a network.
>
> Can you post your complete rvinterf session log?  If you send me your
> ssh public key and your preferred username, I'll make you a user
> account on freecalypso.org and you'll have a www-exported member
> directory through which you can post files.
>
> > rf_table afcparams
> > [numbers]
>
> Your numbers look good to me, they are in the same range of per-unit
> variation as observed on Openmoko-made GTA02 units.
>
> > Mychaela, could you share your fwimage.bin? Just would like to make sure
> > that I run known good build, free of config errors.
>
> https://www.freecalypso.org/members/falcon/fcdev3b/
> magnetite-build-20170502.tar.bz2
>
> Das Signal wrote:
>
> > A possible suggestion, consider trying the cell_log application:
> > Mychaela has reported success in sending a RACH and receiving an
> > IMMASS with the TA.
>
> Yes, that is correct.  I also tried their full mobile application and
> was able to send and receive SMS, and some voice calls too - the latter
> have always been unreliable for me with OsmocomBB software, even on
> pre-existing Calypso hardware.  During that weekend in April when I
> was preparing boards to ship to Serg and to Harald Welte, I tested all
> 8 boards, and for the RF test I used OsmocomBB as that was before I
> developed the manual calibration procedure for the VCXO.
>
> The point is that the board which I sent to Serg *was* tested on my
> end with OsmocomBB's mobile application, and it successfully connected
> to my local cell of Operator 310260 (T-Mobile USA).
>
> Later I developed that manual VCXO calibration procedure and performed
> it on my S/N 001 board (after Serg's and HW's boards already shipped
> out), and I am now able to connect to the same T-Mobile network with
> FC Magnetite (l1reconst config) from my S/N 001 board.  I have not
> tried FC Citrine yet, nor the TCS2/TCS3 hybrid config of Magnetite.
>
> M~
> _______________________________________________
> Community mailing list
> Community at freecalypso.org
> https://www.freecalypso.org/mailman/listinfo/community
>