!GPRS config: fix long-standing AT+COPS chance hanging bug There has been a long-standing bug in FreeCalypso going back years: sometimes in the AT command bring-up sequence of an ACI-only MS, the AT+COPS command would produce only a power scan followed by cessation of protocol stack activity (only L1 ADC traces), instead of the expected network search sequence. This behaviour was seen in different FC firmware versions going back to Citrine, and seemed to follow some law of chance, not reliably repeatable. This bug has been tracked down and found to be specific to !GPRS configuration, stemming from our TCS2/TCS3 hybrid and reconstruction of !GPRS support that was bitrotten in TCS3.2/LoCosto version. ACI module psa_mms.c, needed only for !GPRS, was missing in the TCS3 version and had to be pulled from TCS2 - but as it turns out, there is a new field in the MMR_REG_REQ primitive that needs to be set correctly, and that psa_mms.c module is the place where this initialization needed to be added.

#ifndef _MFW_BAND_H_
#define _MFW_BAND_H_

typedef enum
{	MFW_BAND_Busy= -2,
	MFW_BAND_Fail = -1,
	MFW_BAND_OK,
	MFW_BAND_InProgress
} T_MFW_BAND_RET;

typedef enum
{
	MFW_BAND_MODE_Auto	=  0,
	MFW_BAND_MODE_Manual	=  1
} T_MFW_BAND_MODE;

/* SPR919 - SH - Band is now a bit field*/
/*a0393213 compiler warnings removal - typedef removed*/
enum
{
	MFW_BAND_GSM_900		=	1,
	MFW_BAND_DCS_1800		=	2,
	MFW_BAND_PCS_1900		=	4,
	MFW_BAND_E_GSM			=	8,
	MFW_BAND_GSM_850		=	16
};

T_MFW_BAND_RET band_radio_mode_switch(T_MFW_BAND_MODE mode, UBYTE band);

T_MFW_BAND_RET band_get_radio_modes(T_MFW_BAND_MODE* maxMode, UBYTE *band);

T_MFW_BAND_RET band_get_current_radio_mode(T_MFW_BAND_MODE* mode, UBYTE *band);
#endif /* _MFW_BAND_H_*/