!GPRS config: fix long-standing AT+COPS chance hanging bug There has been a long-standing bug in FreeCalypso going back years: sometimes in the AT command bring-up sequence of an ACI-only MS, the AT+COPS command would produce only a power scan followed by cessation of protocol stack activity (only L1 ADC traces), instead of the expected network search sequence. This behaviour was seen in different FC firmware versions going back to Citrine, and seemed to follow some law of chance, not reliably repeatable. This bug has been tracked down and found to be specific to !GPRS configuration, stemming from our TCS2/TCS3 hybrid and reconstruction of !GPRS support that was bitrotten in TCS3.2/LoCosto version. ACI module psa_mms.c, needed only for !GPRS, was missing in the TCS3 version and had to be pulled from TCS2 - but as it turns out, there is a new field in the MMR_REG_REQ primitive that needs to be set correctly, and that psa_mms.c module is the place where this initialization needed to be added.

/*
 * This header file is a FreeCalypso addition to R2D.  It defines
 * the API for turning BLRR (backlight required for readability)
 * displays on and off, and for communicating different display modes
 * which may translate to different display brightness levels
 * (different backlight intensity levels) on some hw targets.
 */

#ifndef	__R2D_BLRR_API_H
#define	__R2D_BLRR_API_H

#include "rv/rv_general.h"

enum blrr_display_state {
	BLRR_DISPLAY_OFF = 0,
	BLRR_DISPLAY_ON,
	BLRR_DISPLAY_INCALL,
	BLRR_DISPLAY_CHG_BOOT
};

extern T_RV_RET blrr_display_ctrl(enum blrr_display_state);

#endif	/* include guard */