U5 & U6:

	Sockets cover the reference designators

	This should be fixed: these reference designators should be visible
	on a finished board so that if an end user wants to reprogram the
	firmware, s/he would know which flash chip goes into which socket.

C1 & C2 (bypass caps for U5 & U6):

	The caps are too close and are bumping into the socket body;
	should be moved away.

All 0603, 0805 and 1206 footprints:

	The pads don't extend past the part at all in the long direction,
	need to be fixed.

JP1 through JP6:

	The drill size is too small and the header posts don't fit properly.
	Need to increase the drill size.  The assembler says that copying the
	drill size from J4 should do the trick.

	[fixed in OSDCU.pcb]

JP2 & JP3:

	Need to add silk screen markings so that an end user can tell on a
	finished board which pin is 1 without having to flip the board over to
	see the square pad.

J5 & J6:

	Not populated, but expect the same problem as with JP1 through JP6.

	[fixed in OSDCU.pcb]
