ringtools/imy: fix duplicate definition of tdma_durations[] The bug was reported by Vadim Yanitskiy <fixeria@osmocom.org>, although the present fix is slightly different from the contributed patch: because main.c doesn't need this tdma_durations[] array at all, let's simply remove the reference to this array from main.c rather than turn it into an extern. I no longer remember my original thought flow that resulted (by mistake) in tdma_durations[] being multiply defined in main.c and durations.c. My intent might have been to define all globals in main.c and have the reference in durations.c be an extern - and I missed that extern - but without clear memory, I have no certainty. In any case, having this data array defined in the same module that fills it (durations.c) is sensible, so let's make it the new way.

# The present hw parameter file is a minimal config that is appropriate to use
# if the target is known to have a Calypso C05 chip and a Iota ABB chip, but
# nothing else is known.  This minimal config is not usable for flash
# manipulation or for fc-xram, but it may be useful for fc-iram or low-level
# (non-flash) fc-loadtool operations.  This config is also a good choice for
# fc-buzplay and fc-dspromdump.

# The following parameters go into the <p command sent to the boot ROM
pll-config 3/1		# ARM @ 39 MHz, PLL&DSP @ 78 MHz if 26 MHz in
rhea-cntl 0x00		# good for all Calypso platforms

# Perform a Iota poweroff when we are done
exit-mode iota-off