# This configuration is intended to be applicable to all of C11x, C12x,
# C139 and C140.  The "plain" version of compalstage selected below
# should work for all C11x/12x; it will also work on C139/140 phones
# that had the simpler boot code flashed into them, as we do with
# FreeCalypso fw on these phones.  When running loadtools with this config
# on C139/140 phones that still have the official fw in them, one will need
# to specify -h compal -c 1004 to use the inefficient ~15 KiB version of
# compalstage.

compal-stage plain

# Whether we are breaking in through compalstage (as above) or through
# tfc139, the re-enabled Calypso boot ROM is used to load our loadagent
# into IRAM.  The boot ROM will autodetect the Calypso input clock as
# 26 MHz (physical reality) when entered through compalstage, or as
# 13 MHz when entered through tfc139 - the latter results from the
# original fw setting bit 7 in the FFFF:FD02 register (VTCXO_DIV2),
# which the boot ROM does not clear.
#
# However, the following configuration will result in the ARM core
# being clocked at 52 MHz in both cases.

pll-config 4/1
rhea-cntl 0x00

# The remaining settings are carried out via loadagent commands
init-script compal.init

# Flash can be 2 MiB or 4 MiB, will be autodetected, 4 MiB mapping used
# mapped at 0x03000000 like on other targets, see updated compal.init script
flash single-4M 0x03000000

boot-reflash-hack 0x820000 0x10000

# Perform a Iota poweroff when we are done
exit-mode iota-off