comparison loadtools/scripts/gen4.config @ 561:392525355ee7

loadtools/scripts: gtm900.config renamed to gen4.config It turns out that a GTM900 variant exists with 8 MiB flash, thus -h gen8 needs to be used for GTM900 modules as the general case, and the old -h gtm900 config is best renamed to -h gen4, although not currently official for any actual target.
author Mychaela Falconia <falcon@freecalypso.org>
date Thu, 30 Jan 2020 07:10:20 +0000
parents loadtools/scripts/gtm900.config@26bb2c069427
children
comparison
equal deleted inserted replaced
560:641d816b1e91 561:392525355ee7
1 # This config is meant to be applicable to most "generic" or "vanilla"
2 # Calypso devices with just the following properties expected:
3 #
4 # * Calypso chip is C035, meaning it's ok to run the PLL at 104 MHz
5 # and give 52 MHz to the ARM7;
6 # * There is one flash bank on nCS0 and one XRAM bank on nCS1;
7 # * No more than 4 MiB flash, thus no ADD22.
8
9 # The following parameters go into the <p command sent to the boot ROM
10 pll-config 4/1 # 26 MHz in, PLL&DSP @ 104 MHz, ARM @ 52 MHz
11 rhea-cntl 0x00 # good for all Calypso platforms
12
13 # The remaining settings are carried out via loadagent commands
14 init-script basic-4ws-4mb.init
15
16 # Flash configuration
17 flash single-4M 0x03000000
18
19 # Perform a Iota poweroff when we are done
20 exit-mode iota-off