FreeCalypso > hg > freecalypso-tools

annotate loadtools/scripts/gta02.config @ 416:30f6d1c32c6f

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
doc/Flash-boot-defect article removed (no longer relevant) This article is no longer relevant because the issue in question only affected one (1) defective FCDEV3B board which was not and never will be sold.
author Mychaela Falconia <falcon@freecalypso.org>
date Fri, 26 Oct 2018 07:11:08 +0000
parents e7502631a0f9
children 49ee210fc4fb
Ignore whitespace changes - Everywhere: Within whitespace: At end of lines:
rev   line source
0
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
1 # If one is running fc-loadtool from inside the GTA02 (i.e., from the AP,
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
2 # as opposed to an external host connected via the headset jack), the
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
3 # following setting will cause the fc-loadtool utility to power the modem off
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
4 # fully upon exit.
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
5
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
6 exit-mode gta02-cutpwr
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
7
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
8 # The following parameters go into the <p command sent to the boot ROM
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
9 # same values as in pirelli.config, apparently correct for this modem too
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
10
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
11 pll-config 4/1 # 26 MHz in, PLL&DSP @ 104 MHz, ARM @ 52 MHz
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
12 rhea-cntl 0x00 # fastest setting, used by OsmocomBB, presumably correct
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
13
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
14 # Configure memory timings with loadagent commands
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
15 init-script k5a3281.init
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
16
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
17 # Flash type and chip select base address (full access mapping)
e7502631a0f9 initial import from freecalypso-sw rev 1033:5ab737ac3ad7
Mychaela Falconia <falcon@freecalypso.org>
parents:
diff changeset
18 flash k5a32xx_t 0x03000000