view cdg-hybrid/sap/dti2.pdf @ 268:f2e52cab0a73

abb_inth.c: check all interrupt causes, not just one The original code used if - else if - else if etc constructs, thus the first detected interrupt was the only one handled. However, Iota ITSTATREG is a clear-on-read register, thus if we only handle the first detected interrupt and skip checking the others, then the other interrupts will be lost, if more than one interrupt happened to occur in one ABB interrupt handling cycle - a form of rare race condition. Change the code to check all interrupts that were read in this cycle.
author Mychaela Falconia <falcon@freecalypso.org>
date Sun, 13 Jun 2021 18:17:53 +0000
parents 35f7a1dc9f7d
children
line wrap: on
line source

;********************************************************************************
;*** File           : dti2.pdf
;*** Creation       : Wed Mar 11 09:57:59 CST 2009
;*** XSLT Processor : Apache Software Foundation / http://xml.apache.org/xalan-j / supports XSLT-Ver: 1
;*** Copyright      : (c) Texas Instruments AG, Berlin Germany 2002
;********************************************************************************
;*** Document Type  : Service Access Point Specification
;*** Document Name  : dti2
;*** Document No.   : 8411.111.01.002
;*** Document Date  : 2001-09-19
;*** Document Status: BEING_PROCESSED
;*** Document Author: PHE
;********************************************************************************



PRAGMA 	SRC_FILE_TIME 	"Thu Nov 29 09:40:38 2007"
PRAGMA 	LAST_MODIFIED 	"2001-09-19"
PRAGMA 	ID_AND_VERSION 	"8411.111.01.002"






VALTAB 	VAL_version
VAL 	1 	DTI_VERSION_10 	"version 1.0"

VALTAB 	VAL_cause
VAL 	0 	DTI_CAUSE_NORMAL_CLOSE 	"connection is closed by the entity"
VAL 	1 	DTI_CAUSE_UNEXPECTED_PRIMITIVE 	"unexpected primitive received"
VAL 	2 	DTI_CAUSE_UNSUPPORTED_VERSION 	"negotiated version is not supported"

VALTAB 	VAL_p_id
VAL 	0x21 	DTI_PID_IP 	"simple ip packet"
VAL 	0x2D 	DTI_PID_CTCP 	"Van Jacobson compressed TCP/IP header"
VAL 	0x2F 	DTI_PID_UTCP 	"Van Jacobson uncompressed TCP/IP header"
VAL 	0x00 	DTI_PID_UOS 	"unstructured octet stream"

VALTAB 	VAL_st_break_len
VAL 	0 	DTI_BREAK_OFF 	"No break detected"

VALTAB 	VAL_st_flow
VAL 	0 	DTI_FLOW_ON 	"flow control is inactive"
VAL 	1 	DTI_FLOW_OFF 	"flow control is active"

VALTAB 	VAL_st_line_sa
VAL 	0 	DTI_SA_ON 	"SA is inactive"
VAL 	1 	DTI_SA_OFF 	"SA is active"

VALTAB 	VAL_st_line_sb
VAL 	0 	DTI_SB_ON 	"SB is inactive"
VAL 	1 	DTI_SB_OFF 	"SB is active"




VAR 	list_len 	"length in octets of whole data" 	S


VAR 	first 	"pointer to first generic data descriptor" 	L


VAR 	next 	"next generic data descriptor" 	L


VAR 	offset 	"offset in octets" 	S


VAR 	len 	"length of content in octets" 	S


VAR 	size 	"size of buffer in octets" 	S


VAR 	buffer 	"buffer content" 	B


VAR 	link_id 	"link identifier" 	L


VAR 	version 	"Version of DTI" 	L

VAL 	@p_dti2 - VAL_version@ 	

VAR 	cause 	"cause of disconnection" 	B

VAL 	@p_dti2 - VAL_cause@ 	

VAR 	l_buf 	"length of content in bit" 	S


VAR 	o_buf 	"offset of content in bit" 	S


VAR 	buf 	"test data" 	B


VAR 	p_id 	"protocol identifier" 	B

VAL 	@p_dti2 - VAL_p_id@ 	

VAR 	st_flow 	"flow control state" 	B

VAL 	@p_dti2 - VAL_st_flow@ 	

VAR 	st_line_sa 	"line state sa" 	B

VAL 	@p_dti2 - VAL_st_line_sa@ 	

VAR 	st_line_sb 	"line state sb" 	B

VAL 	@p_dti2 - VAL_st_line_sb@ 	

VAR 	st_break_len 	"break length" 	S

VAL 	@p_dti2 - VAL_st_break_len@ 	




COMP 	desc_list2 	 "List of generic data descriptors"
{
 	list_len 	 ; length in octets of whole data
 	first 	 ; pointer to first generic data descriptor
}



COMP 	desc2 	 "generic data descriptor"
{
 	next 	 ; next generic data descriptor
 	offset 	 ; offset in octets
 	len 	 ; length of content in octets
 	size 	 ; size of buffer in octets
 	buffer 	[1] 	 ; buffer content
}



COMP 	sdu 	 "test data"
{
 	l_buf 	 ; length of content in bit
 	o_buf 	 ; offset of content in bit
 	buf 	[1] 	 ; test data
}



COMP 	st_lines 	 "Serial line states"
{
 	st_flow 	 ; flow control state
 	st_line_sa 	 ; line state sa
 	st_line_sb 	 ; line state sb
 	st_break_len 	 ; break length
}



COMP 	parameters 	 "Additional parameters"
{
 	p_id 	 ; protocol identifier
 	st_lines 	 ; serial line states
}






; DTI2_CONNECT_REQ 	0x3750
; DTI2_CONNECT_IND 	0x7750
; DTI2_CONNECT_CNF 	0x7751
; DTI2_CONNECT_RES 	0x3751
; DTI2_DISCONNECT_REQ 	0x3752
; DTI2_DISCONNECT_IND 	0x7752
; DTI2_GETDATA_REQ 	0x3753
; DTI2_READY_IND 	0x7753
; DTI2_DATA_IND 	0x7754
; DTI2_DATA_REQ 	0x3754
; DTI2_DATA_TEST_IND 	0x7755
; DTI2_DATA_TEST_REQ 	0x3755
; DTI2_DUMMY_REQ 	0x3756



PRIM 	DTI2_CONNECT_REQ 	0x3750
{
 	link_id 	 ; link identifier
 	version 	 ; version of DTI
}






PRIM 	DTI2_CONNECT_IND 	0x7750
{
 	link_id 	 ; link identifier
 	version 	 ; version of DTI
}






PRIM 	DTI2_CONNECT_CNF 	0x7751
{
 	link_id 	 ; link identifier
 	version 	 ; Version of DTI
}






PRIM 	DTI2_CONNECT_RES 	0x3751
{
 	link_id 	 ; link identifier
 	version 	 ; Version of DTI
}






PRIM 	DTI2_DISCONNECT_REQ 	0x3752
{
 	link_id 	 ; link identifier
 	cause 	 ; Cause of disconnection
}






PRIM 	DTI2_DISCONNECT_IND 	0x7752
{
 	link_id 	 ; link identifier
 	cause 	 ; Cause of disconnection
}






PRIM 	DTI2_GETDATA_REQ 	0x3753
{
 	link_id 	 ; link identifier
}






PRIM 	DTI2_READY_IND 	0x7753
{
 	link_id 	 ; link identifier
}






PRIM 	DTI2_DATA_IND 	0x7754
{
 	link_id 	 ; link identifier
 	parameters 	 ; Additional parameters
 	desc_list2 	 ; list of generic data descriptors
}






PRIM 	DTI2_DATA_REQ 	0x3754
{
 	link_id 	 ; link identifier
 	parameters 	 ; Additional parameters
 	desc_list2 	 ; list of generic data descriptors
}






PRIM 	DTI2_DATA_TEST_IND 	0x7755
{
 	link_id 	 ; link identifier
 	parameters 	 ; Additional parameters
 	sdu 	 ; test data
}






PRIM 	DTI2_DATA_TEST_REQ 	0x3755
{
 	link_id 	 ; link identifier
 	parameters 	 ; Additional parameters
 	sdu 	 ; test data
}






PRIM 	DTI2_DUMMY_REQ 	0x3756
{
 	desc2 	 ; generic data descriptor
}