SPI SWE: clear any pending boot-time interrupts in spi_init() Charger plug/unplug hw logic in the Iota ABB has no built-in debouncing, thus electrical contact bounce on the charging power connection interface produces a lot of charger plug/unplug interrupts. When we boot in charging mode (charging power present at boot time and is presumably the cause of Switch-ON), some bounce may occur between the initial Iota Switch-ON action and Calypso firmware booting. By clearing any accumulated ITSTATREG interrupts on boot, we prevent these pre-boot interrupts from generating charger plug/unplug events to FCHG, which would upset smooth from-boot charging.

/************* Revision Controle System Header *************
 *                  GSM Layer 1 software 
 * L1_DYN_DWL_MSGTY.H
 *
 *        Filename l1_dyn_dwl_msgty.h
 *  Copyright 2004 (C) Texas Instruments
 *
 ************* Revision Controle System Header *************/
#if (L1_DYN_DSP_DWNLD == 1)

typedef struct 
{
  UWORD16 patch_id;
}T_API_L1_CRC_NOT_OK;
typedef struct 
{
  UWORD16 error;
}T_API_L1_DYN_DWNLD_STOP;

#endif // L1_DYN_DSP_DWNLD == 1