FreeCalypso > hg > fc-tourmaline
view scripts/cfg-template @ 280:82665effff30
keypad boot init overhaul: handle initially held-down keys
This change fixes two previous behavioural defects:
1) On Compal phones, the PWR key had to be released before the boot
sequence would proceed at all - it was stuck in an endless IRQ loop
at the point of Nucleus enabling interrupts, before anything else.
2) On both Compal and sane platforms including Luna, if some regular
non-PWR key was held down at boot time, the boot sequence would
proceed and complete normally, but all non-PWR keypad buttons would
be dead for the remainder of that boot cycle.
The fix is a generic solution - no Compal-specific hack ended up being
needed for the special case of their idiotic PWON-to-ROW4 hw wiring.
| author | Mychaela Falconia <falcon@freecalypso.org> |
|---|---|
| date | Fri, 24 Sep 2021 00:47:12 +0000 |
| parents | b55b47f49638 |
| children |
line wrap: on
line source
[board.cfg] BOARD 41 [chipset.cfg] ANLG_FAM 2 ANLG_PG 0 CHIPSET var [debug.cfg] TI_NUC_MONITOR 0 TI_PROFILER var [dio.cfg] DIOIL_CONFIG 0 [ffs.cfg] TARGET 1 _RVF 1 [l1sw.cfg] AMR var CUST 0 DCO_ALGO 0 IDS var L1_12NEIGH 1 L1_EOTD 0 L1_EOTD_QBIT_ACC 0 L1_GPRS var L1_GTT 0 L1_MIDI 0 L1_VOICE_MEMO_AMR var MELODY_E2 var OP_L1_STANDALONE 0 OP_RIV_AUDIO 1 ORDER2_TX_TEMP_CAL 1 RAZ_VULSWITCH_REGAUDIO 0 SECURITY 0 SPEECH_RECO var TESTMODE 1 TRACE_TYPE 4 VCXO_ALGO 1 [r2d.cfg] R2D_ASM 0 R2D_EMBEDDED_LCD var R2D_LCD_TEST 0 [rf.cfg] RF var RF_FAM var RF_PA var RF_PG var [rv.cfg] RVTOOL 0 TEST 0 _GSM 1 [swconfig.cfg] ALR 1 BT 0 DP 0 DWNLD 1 GSMLITE 0 L1_DYN_DSP_DWNLD var LONG_JUMP 3 MOVE_IN_INTERNAL_RAM 1 OP_WCP 0 PMODE var RVDATA_INTERNALRAM 0 SRVC var TR_BAUD_CONFIG var WCP_PROF 0 [sys.cfg] DSP var STD 6 [trace.cfg] LAYER_DBG 0xFFFFFFFF TRACE_LEVEL_FILTER 5