backlight control on Luna: switch PWL instead of LEDB This change is preliminary toward upcoming rework of backlight control logic in our UI firmware. LEDB does not exist on Tango-based platforms (it is not brought out on Tango modules), thus turning it on and off produces absolutely no effect beyond making L1 disable deep sleep when LEDB is turned on. However, both iWOW DSK and our upcoming FC Caramel2 boards have a PWL LED, so let's switch that LED on and off to indicate the state of the UI firmware's backlight control. Note that we are NOT switching the actual Luna LCD backlight here, even though it is trivially controlled with a GPIO. The reason for this seemingly strange choice is that we don't want to turn this development board LCD backlight off until we bring the higher-level backlight control logic up to par, including new logic to "swallow" the first keypress that turns on the darkened LCD.

/*
 *        Filename l1audio_abb.h
 *  Copyright 2003 (C) Texas Instruments  
 *
 *
 */

#define ABB_L1_WRITE(addr,data) (((data) << 6) | (addr) | 0x01)

void ABB_CAL_UlVolume     (UWORD8 pga_index);
void ABB_CAL_DlVolume     (UWORD8 volume_index, UWORD8 pga_index);
void ABB_UlVolume         (UWORD8 volume_index);
void ABB_DlVolume         (UWORD8 volume_index);
void ABB_DlMute           (BOOL mute);
void ABB_SideTone         (UWORD8 volume_index);
void ABB_Audio_Config     (UWORD16 data);
void ABB_Audio_Config_2   (UWORD16 data); 
void ABB_UlMute           (BOOL mute);
void ABB_Audio_Control    (UWORD16 data);
void ABB_Audio_On_Off     (UWORD16 data);
void ABB_Audio_Volume     (UWORD16 data);
void ABB_Audio_PLL        (UWORD16 data);
void ABB_Audio_VBPop      (UWORD16 data);
void ABB_Audio_Delay_Init (UWORD8 delay);