enable L1_NEW_AEC in l1_confg.h (bold change) The AEC function implemented in DSP ROM 3606 on the Calypso silicon we work with is the one that corresponds to L1_NEW_AEC; the same holds for DSP 34 and even for DSP 33 with more recent patch versions. However, TI shipped their TCS211 reference fw with L1_NEW_AEC set to 0, thus driving AEC the old way if anyone tried to enable it, either via AT%Nxxxx or via the audio mode facility. As a result, the fw would try to control features which no longer exist in the DSP (long vs short echo and the old echo suppression level bits), while providing no way to tune the 8 new parameter words added to the DSP's NDB page. The only sensible solution is to bite the bullet and enable L1_NEW_AEC in L1 config, with fallout propagating into RiViera Audio Service T_AUDIO_AEC_CFG structure and into /aud/*.cfg binary file format. The latter fallout will be addressed in further code changes.

[board.cfg]

BOARD 41

[chipset.cfg]

ANLG_FAM 2
ANLG_PG 0
CHIPSET var

[debug.cfg]

TI_NUC_MONITOR 0
TI_PROFILER var

[dio.cfg]

DIOIL_CONFIG 0

[ffs.cfg]

TARGET 1
_RVF 1

[l1sw.cfg]

AMR var
CUST 0
DCO_ALGO 0
IDS var
L1_12NEIGH 1
L1_EOTD 0
L1_EOTD_QBIT_ACC 0
L1_GPRS var
L1_GTT 0
L1_MIDI 0
L1_VOICE_MEMO_AMR var
MELODY_E2 var
OP_L1_STANDALONE 0
OP_RIV_AUDIO 1
ORDER2_TX_TEMP_CAL 1
RAZ_VULSWITCH_REGAUDIO 0
SECURITY 0
SPEECH_RECO var
TESTMODE 1
TRACE_TYPE 4
VCXO_ALGO 1

[r2d.cfg]

R2D_ASM 0
R2D_EMBEDDED_LCD var
R2D_LCD_TEST 0

[rf.cfg]

RF var
RF_FAM var
RF_PA var
RF_PG var

[rv.cfg]

RVTOOL 0
TEST 0
_GSM 1

[swconfig.cfg]

ALR 1
BT 0
DP 0
DWNLD 1
GSMLITE 0
L1_DYN_DSP_DWNLD var
LONG_JUMP 3
MOVE_IN_INTERNAL_RAM 1
OP_WCP 0
PMODE var
RVDATA_INTERNALRAM 0
SRVC var
TR_BAUD_CONFIG var
WCP_PROF 0

[sys.cfg]

DSP var
STD 6

[trace.cfg]

LAYER_DBG 0xFFFFFFFF
TRACE_LEVEL_FILTER 5