view src/cs/layer1/gtt_include/l1gtt_signa.h @ 287:3dee79757ae4

UI fw: load handheld audio mode on boot We have now reached the point where use of audio mode config files should be considered mandatory. In ACI usage we can tell users that they need to perform an AT@AUL of some appropriate audio mode, but in UI-enabled fw we really need to have the firmware load audio modes on its own, so that correct audio config gets established when the handset or development board runs on its own, without a connected host computer. Once have FC Venus with both main and headset audio channels and headset plug insertion detection, our fw will need to automatically load the handheld mode or the headset mode depending on the plug insertion state. For now we load only the handheld mode, which has been tuned for FC-HDS4 on FC Luna.
author Mychaela Falconia <falcon@freecalypso.org>
date Sat, 13 Nov 2021 03:20:57 +0000
parents 4e78acac3d88
children
line wrap: on
line source

/************* Revision Controle System Header *************
 *                  GSM Layer 1 software 
 * L1GTT_SIGNA.H
 *
 *        Filename l1gtt_signa.h
 *  Copyright 2003 (C) Texas Instruments  
 *
 ************* Revision Controle System Header *************/
 
#if (L1_GTT == 1)

  #define P_GTT ( 0x19 )
  
  // Messages Upper layer <-> L1A
  #define MMI_GTT_START_REQ             ( ( P_GTT << 8 ) |   1 )
  #define MMI_GTT_START_CON             ( ( P_GTT << 8 ) |   2 )
  #define MMI_GTT_STOP_REQ              ( ( P_GTT << 8 ) |   3 )
  #define MMI_GTT_STOP_CON              ( ( P_GTT << 8 ) |   4 )

  // Messages L1S <-> L1A
  #define L1_GTT_START_CON              ( ( P_GTT << 8 ) |   5 )
  #define L1_GTT_STOP_CON               ( ( P_GTT << 8 ) |   6 )

  // Test messages
  #define TST_CLOSE_GTT_LOOP_REQ        ( ( P_GTT << 8 ) |   7 )
  #define TST_CLOSE_GTT_LOOP_CON        ( ( P_GTT << 8 ) |   8 )
  #define TST_OPEN_GTT_LOOP_REQ         ( ( P_GTT << 8 ) |   9 )
  #define TST_OPEN_GTT_LOOP_CON         ( ( P_GTT << 8 ) |  10 )
  #define TST_START_GTT_TEST_REQ        ( ( P_GTT << 8 ) |  11 )
  #define TST_START_GTT_TEST_CON        ( ( P_GTT << 8 ) |  12 )
  #define TST_STOP_GTT_TEST_REQ         ( ( P_GTT << 8 ) |  13 )
  #define TST_STOP_GTT_TEST_CON         ( ( P_GTT << 8 ) |  14 )

#endif // L1_GTT == 1