disable deep sleep when Iota LEDB is on TI's Iota chip docs say that CLK13M must be running in order for LEDB to work, and practical experience on Mot C139 which uses Iota LEDB for its keypad backlight concurs: if Calypso enters deep sleep while the keypad backlight is turned on, the light flickers visibly as the chipset goes into and out of deep sleep. TI's original L1 sleep manager code had logic to disable deep sleep when LT_Status() returns nonzero, but that function only works for B-Sample and C-Sample LT, always returns 0 on BOARD 41 - no check of Iota LEDB status anywhere. Change this code for our current hardware: disable deep sleep when Iota LEDB has been turned on through LLS.

/*
 * BUZZER.H
 *
 * Buzzer and light control
 *
 * Target : ARM 
 *
 * Copyright (c) Texas Instruments 1996
 *
 */

#define BZ_LEVEL       ARMIO_BUZZER
#define LT_LEVEL       ARMIO_LIGHT

// Bit definitions in CNTL
#define BZ_ON			0x01	// start buzzer
#define LT_ON			0x02	// start light

// Buzzer control
void BZ_Init(void);
void BZ_Enable(void);
void BZ_Disable(void);
void BZ_Tone(int f);
void BZ_Volume(int v);
void BZ_IntHandler(void);
void BZ_KeyBeep_ON(void);
void BZ_KeyBeep_OFF(void);

// LCD and keypad Light control
void LT_Enable(void);
void LT_Disable(void);
void LT_Level(SYS_WORD8 level);
SYS_BOOL LT_Status(void);