FreeCalypso > hg > fc-rfcal-tools
comparison INSTALL @ 94:b443d0665c1f
top README and INSTALL files added
| author | Mychaela Falconia <falcon@freecalypso.org> |
|---|---|
| date | Mon, 17 Jul 2017 08:28:57 +0000 |
| parents | |
| children | 037d9200aae4 |
comparison
equal
deleted
inserted
replaced
| 93:20e2b4571cd6 | 94:b443d0665c1f |
|---|---|
| 1 The calibration software needs to be installed on a Unix/Linux machine that is | |
| 2 able to communicate serially with both your CMU200 instrument and your Calypso | |
| 3 devices to be calibrated. Because we use serial communication with the CMU200 | |
| 4 instead of GPIB, no exotic drivers or libraries are needed. However, you do | |
| 5 need to have FreeCalypso host tools (release fc-host-tools-r5 or later) | |
| 6 installed on your system under /opt/freecalypso before you can compile and | |
| 7 install the present calibration software, as we use the rvinterf program from | |
| 8 FC host tools to communicate with Calypso DUTs (or more precisely, with the | |
| 9 L1TM component in their firmware), and we need some rvinterf definitions in | |
| 10 order to compile. | |
| 11 | |
| 12 Once you have fc-host-tools-r5 or later compiled and installed under | |
| 13 /opt/freecalypso, run 'make' to compile the calibration sw. Then run | |
| 14 'make install' to add the calibration programs to your FC software installation | |
| 15 under /opt/freecalypso. | |
| 16 | |
| 17 You will also need to create one or more cable config files corresponding to | |
| 18 your cabling setup(s); see doc/cableconf-example. These cable config files | |
| 19 need to be placed in the /opt/freecalypso/rfcal/cableconf directory, and they | |
| 20 should be given some appropriately descriptive names: | |
| 21 | |
| 22 * If you have a cable setup that terminates in an SMA connector for calibrating | |
| 23 Calypso GSM devices with SMA antenna interfaces, the corresponding cable | |
| 24 config file should be named "sma". | |
| 25 | |
| 26 * If you have a cable setup that terminates in an MS-147 probe connector for | |
| 27 recalibrating Mot C1xx phones or similar, the corresponding cable config file | |
| 28 should be named "ms147". | |
| 29 | |
| 30 * If you have a cable setup that terminates in a Murata SWD/SWF probe for | |
| 31 working with devices like Openmoko GTA0x, the corresponding cable config file | |
| 32 should be named "murata". | |
| 33 | |
| 34 You will then select the cable configuration to be used in a given calibration | |
| 35 session with the -c option to fc-cmu200d. |