FreeCalypso > hg > fc-magnetite
view targets/luna.conf @ 680:ee3ac8c617cb
armio.c: set GPIO2 output high initially
On TI-canonical platforms GPIO2 is DCD modem control output. In TI's
original code the AI_InitIOConfig() function called from Init_Target()
would configure GPIO2 as an output and set the initial output value to
low, but then the init code in uartfax.c called from Init_Serial_Flows()
would immediately change it to high, corresponding to DCD not asserted.
The result is a momentary asserted-state glitch on the DCD output.
The present change eliminates this glitch, setting DCD output to
not-asserted initially like it should be.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Thu, 25 Jun 2020 03:17:43 +0000 |
parents | 0ccda9c065bc |
children |
line wrap: on
line source
LINK_SCRIPT_SRC=src/cs/system/template/gsm_ds_amd8_tango.template TPUDRV_blob=blobs/patches/tpudrv-leonardo.lib FLASH_BASE_ADDR=0 FLASH_SECTOR_SIZE=0x10000