armio.c: set GPIO2 output high initially On TI-canonical platforms GPIO2 is DCD modem control output. In TI's original code the AI_InitIOConfig() function called from Init_Target() would configure GPIO2 as an output and set the initial output value to low, but then the init code in uartfax.c called from Init_Serial_Flows() would immediately change it to high, corresponding to DCD not asserted. The result is a momentary asserted-state glitch on the DCD output. The present change eliminates this glitch, setting DCD output to not-asserted initially like it should be.

/************* Revision Controle System Header *************
 *                  GSM Layer 1 software 
 * L1_DYN_DWL_MSGTY.H
 *
 *        Filename l1_dyn_dwl_msgty.h
 *  Copyright 2004 (C) Texas Instruments
 *
 ************* Revision Controle System Header *************/
#if (L1_DYN_DSP_DWNLD == 1)

typedef struct 
{
  UWORD16 patch_id;
}T_API_L1_CRC_NOT_OK;
typedef struct 
{
  UWORD16 error;
}T_API_L1_DYN_DWNLD_STOP;

#endif // L1_DYN_DSP_DWNLD == 1