view src/cs/services/atp/atp_spp_api_i.h @ 632:d968a3216ba0

new tangomdm build target TCS211/Magnetite built for target leonardo runs just fine on the Tango-based Caramel board, but a more proper tangomdm build target is preferable in order to better market these Tango modems to prospective commercial customers. The only differences are in GPIO and MCSI config: * MCSI is enabled in the tangomdm build config. * GPIO 1 is loudspeaker amplifier control on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output driving high. * GPIO 2 needs to be configured as Calypso input on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output, either high or low is OK.
author Mychaela Falconia <falcon@freecalypso.org>
date Sat, 04 Jan 2020 19:27:41 +0000
parents 945cf7f506b2
children
line wrap: on
line source

/*******************************************************************************
*
* File Name : atp_spp_api_i.h
*
* Internal Definitions for the interface between ATP and SPP SW entity
*
* (C) Texas Instruments, all rights reserved
*
* Version number	: 0.1      Date : 16-Marsh-2000
*
* History			: 0.1  - Created by E. Baissus
*
*
* Author			: Eric Baissus : e-baissus@ti.com
*
*   (C) Copyright 2000 by Texas Instruments Incorporated, All Rights Reserved
******************************************************************************/
#ifndef ATP_SPP_API_I_H
#define ATP_SPP_API_I_H


#include "rv/rv_general.h"
#include "rvf/rvf_api.h"
#include "spp_general.h"
#include "spp_up_interface.h"

// Structure used to store the 'open pending port' information


typedef struct 
{
	T_ATP_SW_ENTITY_ID initiator_id;
	T_ATP_PORT_NB port_nb;
	T_SPP_HANDLE handle;
} T_ATP_SPP_PENDING_PORT_INFO;


typedef enum
{
	ATP_SPP_IS_IND,
	ATP_SPP_IS_CFM
} T_ATP_SPP_IS_IND_OR_CFM;


void atp_spp_to_spp_if_ft(void * message_p);
T_RV_RET atp_spp_open_port_rqst(T_ATP_OPEN_PORT_IND * open_port_ind_p);
T_RV_RET atp_spp_open_port_rsp(void * spp_open_port_rsp_p,T_ATP_SPP_IS_IND_OR_CFM cfm_or_ind);
T_RV_RET atp_spp_port_closed_from_atp(T_ATP_PORT_CLOSED * close_port_p);
T_RV_RET atp_spp_send_to_spp_buffer_nc(T_ATP_NO_COPY_DATA_RDY * atp_no_copy_p);
void atp_spp_from_spp_if_ft(void * message_p);
T_RV_RET atp_spp_reg(void);
T_RV_RET atp_spp_set_atp_signals(T_SPP_LINE_STS * message_p);
T_RV_RET atp_spp_set_spp_signals(T_ATP_SIGNAL_CHANGED * message_p);


#endif