uartfax.c: pull from Tourmaline (GTM900 RI output) In addition to the primary intent of bringing in GTM900 RI output support, pulling uartfax.c wholesale from Tourmaline also changes the initial_time argument in the two NU_Create_Timer() calls from 0 to 1. This change is required for the new version of Nucleus used in Tourmaline and Selenite (and apparently also used by TI in LoCosto), and it is harmless (no effect) for the original TCS211 version of Nucleus used in Magnetite. The new philosophical model being adopted is that Tourmaline is our new development head firmware, whereas Magnetite will now be maintained similarly to how Linux maintainers treat stable kernels: changes will be backported from Tourmaline if they are deemed appropriate for stable modem firmware.

# This patch applies to the Init_Target() function in the init.obj module in
# main.lib; the present version is for making TCS211 run on the Pirelli.
# This patch sets the same memory and peripheral chip select timings and
# widths as Pirelli's fw.

[init.obj]

# value goes into nCS0, nCS1 and nCS3 config registers
.text 66 A4
# the nCS2 setting in our original blob is already correct for the Pirelli

# value goes into nCS4 config reg
.text 72 A7

# nop out the write into 0x02700000

.text 128 C0
.text 129 46