armio.c: make GPIOs 8 & 13 outputs driving 1 on all "classic" targets Calypso GPIOs 8 & 13 are pinmuxed with MCUEN1 & MCUEN2, respectively, and on powerup these pins are MCUEN, i.e., outputs driving 1. TI's code for C-Sample and earlier turns them into GPIOs configured as outputs also driving 1 - so far, so good - but TI's code for BOARD 41 (which covers D-Sample, Leonardo and all real world Calypso devices derived from the latter) switches them from MCUEN to GPIOs, but then leaves them as inputs. Given that the hardware powerup state of these two pins is outputs driving 1, every Calypso board design MUST be compatible with such driving; typically these GPIO signals will be either unused and unconnected or connected as outputs driving some peripheral. Turning these pins into GPIO inputs will result in floating inputs on every reasonably-wired board, thus I am convinced that this configuration is nothing but a bug on the part of whoever wrote this code at TI. This floating input bug had already been fixed earlier for GTA modem and FCDEV3B targets; the present change makes the fix unconditional for all "classic" targets. The newly affected targets are D-Sample, Leonardo, Tango and GTM900.

#define	CONFIG_TARGET_C139	1
#define	CONFIG_TARGET_C1XX	1
#define	CONFIG_TARGET_COMPAL	1
#define	USE_TSPACT2_FOR_TXLOW	1
#define	GPIO1_SPEAKER_CTRL	0
#define	UARTFAX_CLASSIC_DTR_DCD	0