FreeCalypso > hg > fc-magnetite
view src/cs/layer1/tpu_drivers/source0/tpudrv2.h @ 639:026c98f757a6
tpudrv12.h & targets/gtm900.h: our current support is for MGC2GSMT version only
As it turns out, there exist two different Huawei-made hw platforms both
bearing the marketing name GTM900-B: one is MG01GSMT, the other is MGC2GSMT.
The two are NOT fw-compatible: aside from flash chip differences which
should be handled by autodetection, the two hw platforms are already known
to have different RFFEs with different control signals, and there may be
other differences not yet known. Our current gtm900 build target is for
MGC2GSMT only; we do not yet have a specimen of MG01GSMT on hand, hence
no support for that version will be possible until and unless someone
provides one.
| author | Mychaela Falconia <falcon@freecalypso.org> |
|---|---|
| date | Thu, 30 Jan 2020 18:19:01 +0000 |
| parents | 945cf7f506b2 |
| children |
line wrap: on
line source
/****************** Revision Controle System Header *********************** * GSM Layer 1 software * Copyright (c) Texas Instruments 1998 * * Filename tpudrv2.h * Copyright 2003 (C) Texas Instruments * ****************** Revision Controle System Header ***********************/ /***********************************************************/ /* */ /* Used Timing definitions given in "L1_TIME.H" */ /* -------------------------------------------- */ /* */ /* START_RX_FB STOP_RX_FB */ /* START_RX_SB STOP_RX_SB */ /* START_RX_SNB STOP_RX_SNB */ /* START_RX_NNB STOP_RX_NNB */ /* START_RX_PW_1 STOP_RX_PW_1 */ /* START_RX_FB26 STOP_RX_FB26 */ /* START_TX_NB STOP_TX_NB */ /* START_RX_RA STOP_RX_RA */ /* */ /***********************************************************/ // BB Timings #define VG_CAL_RX_DELAY 65 #define VG_CAL_TX_DELAY 143 #define VG_BDLON_DELAY 70 #define VG_BULOFF_DELAY 35 #define VG_BULON_DELAY 159 #if ((ANLG_FAM == 1) || (ANLG_FAM == 2) || (ANLG_FAM == 3)) #define OM_CAL_RX_DELAY 65 #define OM_CAL_TX_DELAY 230 #define OM_BDLON_DELAY 166 #define OM_BULOFF_DELAY 35 #define OM_BULON_DELAY 250 #define SL_SU_DELAY1 4 #define SL_SU_DELAY2 3 #endif #define RA_TRANSMIS_DURATION ( RA_BURST_DURATION + 46L ) #define NB_TRANSMIS_DURATION ( NB_BURST_DURATION_UL + 29L ) #define START_TX_NB ( 4984L ) // Calibration time is reduced of 4 GSM bit due to a slow APC ramp #define STOP_TX_NB ( START_TX_NB + NB_TRANSMIS_DURATION ) #define STOP_TX_RA ( START_TX_RA + RA_TRANSMIS_DURATION ) #ifdef TPUDRV2_C #if ((ANLG_FAM == 1) || (ANLG_FAM == 2) || (ANLG_FAM == 3)) const unsigned short RF_Sleep[] ={ /*** Immediate ***/ TPU_MOVE(TSP_SPI_SET1, TSP_ENA_POS_MSB), TPU_MOVE(TSP_SPI_SET2, TSP_ENA_POS_MSB | TSP_ENA_POS), 0 }; const unsigned short RF_Wakeup[] ={ /*** Immediate ***/ TPU_MOVE(TSP_SPI_SET1, 0x00), TPU_MOVE(TSP_SPI_SET2, TSP_ENA_POS), 0 }; /*--------------------------------------------------------------------------------------------------------------*/ /* Serial link delay for OMEGA. this delay includes */ /* TSP register programming and serialization of data to OMEGA */ /* */ /* */ /* 4991 4992 4993 4994 4995 4996 4997 */ /* ---------------------------------------------------------------------------------------------- */ /* | | | | | | | */ /*OMEGA | AT(4991) | Clock conf | Nb of bit | Load data | Send write | Serialization */ /* | | | to shift | to shift | command | | */ /* ---------------------------------------------------------------------------------------------- */ /* | | | | | | | */ /* VEGA | | | | | | AT(4996) | TSPACT */ /* | | | | | | | */ /* ------------------------------------------------------------------------------------------|--- */ /* <------------------------------------------------------------------> | */ /* SL_SU_DELAY1 | */ /* V */ /* ACTION ON WINDOW */ /* */ /* When the TSP port is already configured is not necessary to configure the clock and the number of bits */ /* */ /* */ /* 4998 4999 0 1 2 */ /* ------------------------------------------------------------------- */ /* | | | | | | */ /*OMEGA | AT(4998) | Load data | Send write | Serialization | */ /* | | to shift | command | | | */ /* ---------------------------------------------------------------------- */ /* | | | | | | */ /* VEGA | | | | AT(4996) | TSPACT */ /* | | | | | | */ /* ------------------------------------------------------------|------- */ /* <---------------------------------------> | */ /* SL_SU_DELAY2 | */ /* V */ /* ACTION ON WINDOW */ /* */ /* */ /* NOTE : WITH THIS IMPLEMENTATION THE OMEGA SCENARIO ANTICIPATES THE ACTION ON WINDOW SIGNAL OF 347 ns. */ /* ANYWAY ACTION IS TAKEN IN THE SAME QB INTERVAL */ /* */ /* */ /*--------------------------------------------------------------------------------------------------------------*/ /***********************************************************/ /* BASEBAND TPU SCENARIOS FOR OMEGA */ /***********************************************************/ #if ((CHIPSET == 4) || (CHIPSET == 7) || (CHIPSET == 8) || (CHIPSET == 10) || (CHIPSET == 11)) // Samson TPU scenario: add 1 bit to reception window for DMA thres = 2 const SYS_UWORD16 VG_DlNormalBurst [] = { TPU_AT (START_RX_SNB -VG_BDLON_DELAY - SL_SU_DELAY1 ), // AT(4991) // TPU_MOVE (TSP_SPI_SET1, TSP_CLK_RISE), TPU_MOVE (TSP_CTRL1,6), TPU_MOVE (TSP_TX_REG_1,BDLON), TPU_MOVE (TSP_CTRL2, TC2_WR), TPU_AT (START_RX_SNB - VG_CAL_RX_DELAY - SL_SU_DELAY2), // AT(4998) TPU_MOVE (TSP_TX_REG_1,BDLON | BDLCAL), TPU_MOVE (TSP_CTRL2, TC2_WR), TPU_AT (START_RX_SNB - SL_SU_DELAY2), // AT(63) TPU_MOVE (TSP_TX_REG_1,BDLON | BDLENA), TPU_MOVE (TSP_CTRL2, TC2_WR), TPU_AT (STOP_RX_SNB - SL_SU_DELAY2), // AT(699) TPU_MOVE (TSP_TX_REG_1,0x00), TPU_MOVE (TSP_CTRL2, TC2_WR), 0 }; // HERCULES TPU scenario const SYS_UWORD16 VG_DlFrequencyBurstIdle [] = { TPU_AT (START_RX_FB - VG_BDLON_DELAY -SL_SU_DELAY1 ), // AT(4991) // TPU_MOVE (TSP_SPI_SET1, TSP_CLK_RISE), TPU_MOVE (TSP_CTRL1,6), TPU_MOVE (TSP_TX_REG_1,BDLON), TPU_MOVE (TSP_CTRL2, TC2_WR), TPU_AT (START_RX_FB - VG_CAL_RX_DELAY -SL_SU_DELAY2), // AT(4998) TPU_MOVE (TSP_TX_REG_1,BDLON | BDLCAL), TPU_MOVE (TSP_CTRL2, TC2_WR), TPU_AT (START_RX_FB - SL_SU_DELAY2), // AT(63) TPU_MOVE (TSP_TX_REG_1,BDLON | BDLENA), TPU_MOVE (TSP_CTRL2, TC2_WR), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (STOP_RX_FB - SL_SU_DELAY2), // AT(2119) TPU_MOVE (TSP_TX_REG_1,0X00), TPU_MOVE (TSP_CTRL2, TC2_WR), 0 }; #else /* HERCULES TPU scenario */ const SYS_UWORD16 VG_DlNormalBurst [] = { TPU_AT (START_RX_SNB -VG_BDLON_DELAY - SL_SU_DELAY1 ), // AT(4991) // TPU_MOVE (TSP_SPI_SET1, TSP_CLK_RISE), TPU_MOVE (TSP_CTRL1,6), TPU_MOVE (TSP_TX_REG_1,BDLON), TPU_MOVE (TSP_CTRL2, TC2_WR), TPU_AT (START_RX_SNB - VG_CAL_RX_DELAY - SL_SU_DELAY2), // AT(4998) TPU_MOVE (TSP_TX_REG_1,BDLON | BDLCAL), TPU_MOVE (TSP_CTRL2, TC2_WR), TPU_AT (START_RX_SNB - SL_SU_DELAY2), // AT(63) TPU_MOVE (TSP_TX_REG_1,BDLON | BDLENA), TPU_MOVE (TSP_CTRL2, TC2_WR), TPU_AT (STOP_RX_SNB - SL_SU_DELAY2), // AT(699) TPU_MOVE (TSP_TX_REG_1,0x00), TPU_MOVE (TSP_CTRL2, TC2_WR), 0 }; // HERCULES TPU scenario const SYS_UWORD16 VG_DlFrequencyBurstIdle [] = { TPU_AT (START_RX_FB - VG_BDLON_DELAY -SL_SU_DELAY1 ), // AT(4991) // TPU_MOVE (TSP_SPI_SET1, TSP_CLK_RISE), TPU_MOVE (TSP_CTRL1,6), TPU_MOVE (TSP_TX_REG_1,BDLON), TPU_MOVE (TSP_CTRL2, TC2_WR), TPU_AT (START_RX_FB - VG_CAL_RX_DELAY -SL_SU_DELAY2), // AT(4998) TPU_MOVE (TSP_TX_REG_1,BDLON | BDLCAL), TPU_MOVE (TSP_CTRL2, TC2_WR), TPU_AT (START_RX_FB - SL_SU_DELAY2), // AT(63) TPU_MOVE (TSP_TX_REG_1,BDLON | BDLENA), TPU_MOVE (TSP_CTRL2, TC2_WR), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (0), TPU_AT (STOP_RX_FB - SL_SU_DELAY2), // AT(2119) TPU_MOVE (TSP_TX_REG_1,0X00), TPU_MOVE (TSP_CTRL2, TC2_WR), 0 }; #endif // HERCULES TPU scenario for Omega windows reset const SYS_UWORD16 VG_Omega_win_reset[] = { TPU_MOVE (TSP_SPI_SET1, TSP_CLK_RISE), TPU_MOVE (TSP_CTRL1,6), TPU_MOVE (TSP_TX_REG_1,0x00), TPU_MOVE (TSP_CTRL2, TC2_WR), 0 }; #endif #else extern const SYS_UWORD16 VG_DlNormalBurst[]; extern const SYS_UWORD16 VG_DlFrequencyBurstIdle[]; #endif