new tangomdm build target TCS211/Magnetite built for target leonardo runs just fine on the Tango-based Caramel board, but a more proper tangomdm build target is preferable in order to better market these Tango modems to prospective commercial customers. The only differences are in GPIO and MCSI config: * MCSI is enabled in the tangomdm build config. * GPIO 1 is loudspeaker amplifier control on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output driving high. * GPIO 2 needs to be configured as Calypso input on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output, either high or low is OK.

--- a/src/cs/layer1/tpu_drivers/source0/tpudrv12.h	Sat Jan 04 19:07:02 2020 +0000
+++ b/src/cs/layer1/tpu_drivers/source0/tpudrv12.h	Sat Jan 04 19:27:41 2020 +0000
@@ -234,7 +234,8 @@
 #define TEST_TX_ON    0
 #define TEST_RX_ON    0
 
-#if defined(CONFIG_TARGET_LEONARDO) || defined(CONFIG_TARGET_ESAMPLE)
+#if defined(CONFIG_TARGET_LEONARDO) || defined(CONFIG_TARGET_ESAMPLE) || \
+	defined(CONFIG_TARGET_TANGO)
 
   // 4-band config (E-sample, P2, Leonardo)
   #define FEM_7         BIT_2     // act2